Keurig Water Filter Replacement Instructions

Insert the filter cartridge. How to install water filter cartridge on a Keurig K-Duo or Keurig Duo EssentialsKeurig Duo How to descale.

Pin On Best Way Of Omnipure Water Filters Installation

Rinse the cartridge for 60 seconds once complete.

Keurig water filter replacement instructions. Simply twist the clear plastic filter housing until it comes loose from the bottom of the water reservoir. Simply grasp the handle and insert it into your empty removable water reservoir. If you have a K-Classic brewer you will need to check your serial number prior to purchasing a water filter.

Soak the charcoal filter cartridge for 5 minutes in fresh water. If you have a Keurig Water Filter install it now. Do not use distilled water.

Simply grasp the handle and insert it into your empty removable water reservoir. How to Replace Keurig 20 Water Filters in K350 ModelAlways read your instructions carefully for safety measuresThe Keurig water filter installation proce. Insert the cartridge into the upper filter holder.

Soak the cartridge in a cup of fresh water for 5 minutes. On the bottom of the handle press in the tabs on both sides of the base at the same time and pull down to separate. Scan this QR code with your smartphone for step-by-step videos on cleaning descaling and more.

To use the Water Filter soak and insert the filter cartridge in the bottom of the handle assembly. Activate the charcoal cartridge that comes with your filter assembly by soaking it in water for about 5 minutes and then rinse it in fresh water for another minute. To install the Keurig Water Filter simply follow the below steps.

Remove the old charcoal water filter from the housing by unsnapping the bottom filter holder. Empty the water from the Water Reservoir. If your serial number begins with 44 45 or 48 you will need the K-Classic Water Filter.

While the cartridge soaks wash. Be sure to empty the reservoir before continuing to the next step. To use the Water Filter soak and insert the filter cartridge in the bottom of the handle assembly.

Step 1 Water Filter Remove the water reservoir from the Keurig by lifting it upwards and pulling it outwards. If your serial number begins with 55 you will need the Tall Handle Water Filter. Remove the water reservoir lid then lift the reservoir straight up to remove it.

Be sure to push down firmly all the way down to correctly attach the Water Filter to the inside of your removable water reservoir. Once the existing water filter in your Keurig is spent replacing it with a new one will take less than 10 minutes. Insert a new fresh water filter cartridge and snap the filter holder back on so that the filter is securely in place.

If there is a Keurig Water Filter remove and TIME TO REPLACE THE KEURIG WATER FILTER VISIT KEURIGCOM TO PURCHASE set aside. Be sure to push down firmly all the way down to correctly attach the Water Filter to the inside of your removable water reservoir. Rinse the now soaked cartridge for 1 minute.

If you need help locating your serial number click here for a helpful guide. Start by soaking a new charcoal filter in a cup of water for 5 minutes or so. Page 16 30 minutes then continue with the fresh water rinse.

Rinse the mesh in the lower filter holder. Refer to your Water Filter Starter Kit for instructionsRinse reservoir with fresh water and fill to the MAX FILL line.

Pin On My Posh Closet